
Licensed crews, honest pricing, and roofs built to beat Kentucky weather
Best roofing contractor in Florence for roofs that hold
When you need the Best roofing contractor in Florence, you need a crew that shows up, tears off clean, and leaves a roof that sheds water the way it should. We handle shingle, metal, tile and flat roofs across Florence and Boone County. Storm damage, leaks, full replacements, commercial buildings. Call (844) 799-4703 and we'll get eyes on your roof fast.
What's included
What our roofing service covers
Every job starts with a full inspection and a written scope. What follows depends on whether you need a repair, a replacement, or a commercial membrane system. Here is what is included as standard on our roofing work.
Full roof inspection
We walk the roof, check the attic from inside, and run a moisture meter on any suspect decking. An infrared camera catches wet insulation you cannot see from the surface. You get photos and a written report within 24 hours.
Tear-off and disposal
Old shingles come off with shingle removers and roofing hammers, and we haul every pound to the dumpster. Decking gets inspected board by board. Soft or delaminated sheathing gets replaced before anything new goes down.
Underlayment and flashing
Synthetic underlayment covers the field, ice and water shield goes in the valleys and along the eaves, and new flashing seals every chimney, pipe boot, and skylight. That layer is what actually keeps water out.
Ventilation and ridge vents
Poor ventilation cooks shingles from underneath and shortens roof life. We cut ridge vents, check intake at the soffits, and balance the system so hot attic air escapes instead of baking your new roof from below.
Warranty registration
We register the manufacturer warranty in your name the day the job closes. GAF and Owens Corning systems carry 25-year material coverage when installed to spec. You get the paperwork in hand, not a promise to mail it later.
Service overview
What the Best roofing contractor in Florence actually does
Roofing work is not glamorous, but it is precise. A proper install starts with tearing off old material, inspecting the deck for soft spots, then laying synthetic underlayment and ice and water shield along the eaves and valleys before a single shingle goes down. We run a chalk line so courses stay straight, drive roofing nails to the manufacturer's depth, and cut ridge vents so the attic breathes. Skip any of those steps and you get leaks in three years instead of a roof that lasts twenty-five.
Florence sits in Boone County where we get hail in spring, 90-degree summers, and ice dams in January. That swing punishes cheap work. Most of the calls we run are for missing shingles after a storm, flashing failure around chimneys, and ponding water on flat commercial roofs near the airport corridor. If you've been searching for the best roofing contractor in Florence KY near me, you're probably already seeing a stain on the ceiling or a shingle in the yard.
The service timeline
How a roof job runs start to finish
The process flexes to the condition, but these checkpoints keep decisions clear.
Inspection
We walk the roof, check the attic from inside, and run a moisture meter on any stained decking. An infrared camera catches wet insulation you cannot see. You get photos of every problem area and a written scope within 24 hours.
Estimate
The estimate breaks out tear-off, materials, labor, and disposal separately. We list the shingle brand and color, the underlayment type, and the flashing details. You see the number before anyone touches your roof, and it does not change unless we find hidden damage.
Tear-off and decking
Crews strip the old roof with shingle removers and roofing hammers, then inspect every sheet of decking. Soft or delaminated boards get replaced. We re-nail loose sheathing and check the framing around chimneys and skylights before moving on.
Install
Ice and water shield goes along the eaves and valleys, synthetic underlayment covers the field, and new flashing seals every penetration. Shingles get nailed to spec, ridge vents go on last, and we run a magnetic sweep of the yard twice for nails.
Final walkthrough
You and the foreman walk the property together. We check gutters, downspouts, and the ground for debris, then hand over the warranty paperwork and the manufacturer registration. If anything looks off in the first year, you call us and we come back.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Roofing nail gun
Drives nails to consistent depth and angle across thousands of shingles. Hand-nailing a full roof leaves high nails that back out and puncture the shingle above.
Shingle remover
Strips old shingles fast without gouging the decking underneath. A clean tear-off lets us inspect every board for rot before new material goes down.
Moisture meter
Reads the water content in decking and insulation. It tells us whether a stain is an active leak or an old one that already dried out.
Infrared camera
Sees temperature differences that reveal wet insulation behind drywall and under decking. It catches hidden water damage that a visual inspection misses.
Chalk line
Snaps straight reference lines so shingle courses stay level across the whole roof. Crooked courses are the first thing an inspector notices on a resale.
Safety harness
Fall protection on every steep-slope job. Our crews are OSHA 10 and OSHA 30 trained and harnessed on any roof above six feet.
Tin snips
Cuts flashing, drip edge, and metal valley material to fit around chimneys, vents, and skylights. Clean cuts mean tight seals that do not leak.
Use cases
When to call a roofing crew
These examples show how the service framework adapts rather than forcing every call through one repair.

Flat commercial roof near the airport
A property manager had ponding water on a 12,000-square-foot flat roof that three contractors wanted to tear off entirely. The membrane was 14 years old with failed seams at the parapet and standing water in two low spots after every heavy rain. → We repaired the Firestone membrane, heat-welded the failed seams, and added tapered insulation to correct the slope toward the scuppers. The job took four days and saved roughly $18,000 against a full tear-off. No ponding after the next storm.
Leak traced in a Seven Points ranch
A ceiling stain appeared in the hallway of a 1970s ranch, but the roof above it looked fine. Two previous contractors replaced shingles directly over the stain and the leak came back both times. The homeowner was ready to replace the whole roof. → Our moisture meter and infrared camera traced the leak to a failed pipe boot ten feet away from the stain. We replaced the boot, resealed the flashing, and hose-tested the repair. Total cost was under $400 and the roof had another decade of life left.
Problems we solve
Roof problems we fix across Florence
Most roof calls start with one of these four. Catch them early and you are looking at a repair. Wait a season and you are looking at a replacement.
Roof leaks showing as ceiling stains
We trace the leak with a moisture meter and infrared camera, repair the failed flashing or boot, then hose-test the fix before we leave. Most leak repairs run two to four hours and cost a fraction of a replacement.
Missing shingles after hail or wind
We match your existing shingle color and profile, seal the replacement nails, and inspect the surrounding field for lifted tabs. If the damage is widespread, we document it for an insurance claim and meet your adjuster on site.
Ponding water on flat commercial roofs
We repair Firestone and Carlisle SynTec membranes, reseal terminations, and correct drainage with tapered insulation. Fixing the slope is what stops the ponding from coming back next winter.
Ice dams along the eaves in January
We add ice and water shield along the eaves, correct attic ventilation with ridge vents and soffit intake, and seal air leaks that let warm air into the attic. That combination stops ice dams at the source.
Who is the best roofing contractor in Florence KY?
The best roofing contractor in Florence KY is the one that shows you photos of your roof, gives you a written scope, and installs to manufacturer spec so the warranty holds. We have been doing that since 2022, hold GAF and Owens Corning Preferred status, and carry full Kentucky licensing and insurance. Call (844) 799-4703 and we will inspect your roof within 24 hours.
How do I choose the best roofer in Florence Kentucky?
Ask three questions: are you licensed and insured in Kentucky, what manufacturer certifications do you hold, and will you put the scope in writing before work starts. A top rated roofer Florence Kentucky homeowners trust will answer all three without hesitation. We carry OSHA 30 cards, install GAF and CertainTeed systems, and hand you the written scope before we touch your roof.
What makes a roofing contractor the best in Florence KY?
Documentation, installation spec, and follow-through. A roof is only as good as the underlayment and flashing underneath it. We use synthetic underlayment, ice and water shield in the valleys, and new flashing at every penetration. Then we register the manufacturer warranty in your name. That combination is what separates a 10-year roof from a 25-year roof.
Are the best roofers in Florence KY licensed and insured?
Yes. We carry the Kentucky roofing license plus full liability and workers comp coverage. Every crew member holds an OSHA 10 or OSHA 30 card. If a contractor cannot show you a certificate of insurance before starting, walk away. Storm damage work in Boone County attracts out-of-state crews every spring, and uninsured labor becomes your problem if someone gets hurt on your roof.
Ready when you are
Get the Best roofing contractor in Florence on your roof
One call gets a licensed inspector on your roof within 24 hours. We document everything, price it in writing, and install to manufacturer spec so the warranty holds. Call (844) 799-4703 now.

Talk with the local team
Request Best roofing contractor
Call (844) 799-4703 any time, day or night, and a real person picks up. For standard inspections and estimates we schedule within 24 to 48 hours, and emergency leak calls get same-day priority. You can also email [email protected] with photos of the problem and we will get back to you with next steps.



